Hey guys, Bob forwarded me some additional information
Pre entry deadline is apparently Sept 13.
Entry information can be found at http://www.cra-mn.com/shop/index.php/
If you have any questions about pre entry you can email the CRA at racereg@cra-mn.com
Also here is a link and information from the CRA's rulebook. Take a look to insure you bike is legal
i would direct them to the rulebook:
http://www.cra-mn.com/wordpress/wp-c...40321_rev2.pdf
Section 11 focuses on the Ninja 250 cup:
All motorcycles must meet the standards of Section 6 as well as the following:
Rules apply from Section 7 Supersport motorcycles unless addressed below.
1) US market Kawasaki Ninja 250 motorcycles only.
2) Engine, transmission, air box and velocity stacks must remain OEM stock and
unaltered.
3) Carburetor needles and jets are the only items allowed for adjusting carburetion.
4) Aftermarket windscreen may be used of the same size as OEM. Double Bubble
type screens may not be used.
5) Kickstand mounting tab on the frame is required to be removed from 2008 to
2010 models.
6) US market Kawasaki Ninja 250 ECU must be used.
7) Standard unleaded pump gas only (94 octane or less). No “race gas” allowed.
Section 6 and 7 call out safety wire/bike prep , tire, and other update specifications.
Hope that helps...
Joe