I am looking for the length from either one axle spacer (bake side) to the other side (cush drive) for a 1st gen SV650 or the hub bearing from left to right.

I have a 2nd gen rear wheel here and it is around 8-10mm too wide for this project bike I am playing with. I know the cush drives are the same for both years but are not sure about hub/bearing width.

I can have a 2nd gen wheel/cush drive, brake caliper machined down easy enough, but I have to buy a wheel (my wife wont let me use her SV650 wheel :? ) so if a 1st gen works better so be it. I dont want to use the torque arm brake caliper so either way it will have the 2nd gen brakes on it.

TIA

Aaron